Operating instructions
The operating instructions for your new QuikClean system are very simple …
There aren’t any!
That’s right, your QuikClean built-in cleaning and circulation system is so
advanced, yet so simple, that it requires no operating procedures or even
routine maintenance to keep it operating at peak efficiency. Simply maintain
pump operating speed and times, and clean the pool filter, skimmer, Leaf
Vac™ and pump baskets as you normally would. That is all there is to it. Your
QuikClean system will operate automatically.
Operating time
The operating time of your QuikClean system will depend on site environmental
conditions, the installation layout and the system’s interaction with other pool
components.
If you have a single-pump cleaning and circulation system, the pump would
typically operate in cleaning mode for at least two-six hours per day. The pump
may then drop back to a low speed setting for the pool filtration cycle only.
If you have a two-pump layout, the QuikClean system pump will need to
operate at the same time as the pool filtration system. This ensures debris is
removed by the drain/s and skimmer/s at the same time.
Operating times should be no longer than required to maintain your pool in a
clean, clear and sanitised state. Sun, wind, rain, dust and other environmental
factors will need to be considered and your system may require additional
operating time during summer months or periods of heavy use.
Note: To ensure adequate filtration and turnover rate, your filtration operating
time should always be at least six hours per day.
In the event of a storm or other adverse pool conditions, you may need to
vacuum your pool or increase the QuikClean operating time to remove debris.
Page 3