Cooke & Lewis CLIND1BK-C, Руководство пользователя

Страница: 57 / 60

57
Installation
01
02
Cut out worktop to supplied dimensions shown in (fig 1) with suitable equipment
and seal the cut edge with appropriate sealant.
[04]
x 1
SILICONE
[02]
x 2
[03]
x 2
Using a screwdriver and 2x screws provided [03] mount the brackets on the hob adjusting
the bracket to suit the work surface thickness.
Figure (2)
Caution:
For safety, the gap between the hob and any cupboard above it should be at least 750 mm.
3. Fix the hob to the worktop using the four brackets on the base of the hob. The position of
the brackets can be adjusted according to the thickness of the top.
Caution:
(1) The induction hob must be installed by a properly qualified person.
Never try to install the appliance yourself.
(2) The induction hob must not be installed above refrigerators, freezers, dishwashers or
tumble dryers.
(3) The induction hob should be installed so that optimum radiation of heat is possible.
(4) The wall and the area above the hob should be able to withstand heat.
(5) To avoid any damage, the sandwich layer and adhesive should be heat-resistant.
- 4 -
Air intake
Air exit
mini 5 cm
mini 5 mm
mini 2 cm
mini 750 mm
Make sure the hob is correctly installed as shown in Figure(2).
SILICONE
Effectuez une découpe dans le plan de travail conformément aux dimensions
indiquées (fig. 1) à l'aide des outils adéquats et appliquez du joint sur les bords de
Avec un tournevis et les 2 vis fournies [03], positionnez les pattes de fixation sur la table à
induction en les ajustant à l'épaisseur du plan de travail.