Convotherm Mini Combi with Easy Touch, Руководство по обслуживанию и запасным частям

Страница: 71 / 75

easy
touch
OEB OES OGB OGS Error
message
Error description
Possible cause or remedy
5.1 Error messages 5.1 Error messages 5.1 Error messages 5.1 Error messages 5.1 Error messages 5.1 Error messages 5.1 Error messages 5.1 Error messages
E00.0 No error
•
Previous error no longer exists e.g. not
enough water or excessive temperature (the
actual error can be queried in the logbook)
E01.0
ID=33
Not enough water
in
steam generator
(water level could
not be reached
within 3 minutes)
•
Tap closed
•
Soft water connection not connected to
water supply
•
Dirt filter in the solenoid valve or in the mains
water connection dirty
•
Water level sensor calcified (insulated) or
defective
•
Through the use of non-original
CONVOTHERM cleaners, foaming in the
steam generator and insulating film on double
level sensor
•
Filling gap in the steam generator is closed
by calcium deposits
•
Water conductance too low through
softening
•
Solenoid valve Y3 faulty
•
Injection nozzle in non-return device blocked
•
Steam generator calcified
•
Contact problems between steam generator
and housing (earth connection)
•
Contact problems between water level
sensor and terminal strip X15 of the control
module
E01.0
ID=33
Not enough water
(water pressure
below 0.5 bar 3
seconds after
valve switched
through)
•
Tap closed
•
Solenoid valve Y4 faulty
•
Pressure switch S1 defective
•
Dirt filter in the solenoid valve or in the mains
water connection dirty
•
T-piece for pressure switch / manometer or
injection nozzle in water supply blocked /
dirty Clean with needle
•
Contact problems between pressure switch
and terminal strip X15 of the control module
•
Appliance not connected to soft water and
therefore inlet calcified
E01.1 Level reached too
slowly
•
Filling time of steam generator too long;
Possible cause: Water supply not completely
open or supply blocked
11 - 21
70
70