Rear Panel
1. S-Video-
Use an S-Video cable to connect the S-Video output of the
source video equipment to the S-Video input port.
2. Composite Video-
This is the C-Video input port. Use a composite
video cable to connect the composite video output of the source
equipment to the C-Video input port.
3. YCbCr input-
Use a 3 RCA to 3 RCA YCbCr to connect the YCbCr
output of the source video equipment to the connector labeled YCbCr.
Note that the plugs colours have to match with the colour of the RCA
Jacks.
4. PC In- Computer RGB with H & V Sync-
Connect the source
computers VGA output signal to the HD 15 connector PC In. This
computer input signal is not scaled but is available for pass-through when
the video scaler is in the PC In (Bypass) mode. Connect the scaled output
to your projector, PDP or LCD display.
5. RGB/YPbPr Output-
The HD-15 D-Sub connector is shared by
PC/RGBHV output and HDTV/YPbPr output. When PC/RGBHV output
resolution is selected, use the HD-15 to HD-15 VGA cable to connect the
output to the PC input of your display monitor. When HDTV/YPbPr
output is selected, use the HD-15 to YpbPr 3 x RCA cable to connect the
output to the YPbPr input of you HDTV display.
6.
RS 232-
This is the 9-Pin D-Sub connector for connecting to your PC
or other control console for remote control.
7.
DC Power Jack-
This is the DC power supply input port.
Remote Control
1.
Power-
This is the power on and off button.
2.
Display-
This button allows you to enable or disable the on screen
display of the resolution information.
3.
C-Video-
Press the button to select composite video as input source.
4.
S-Video-
Press the button to select S-Video as input source.
5.
YCbCr-
Press this button to select YCbCr as the input source.
6.
PC-
Press the button to select PC input looping through to the output.
