Conversor TV Pro, Руководство пользователя

Страница: 8 / 24

8
Setting up Conversor Pro for the First Time
4. Setting up the Receiver
The Conversor Pro receiver has a green light when it is
“paired” correctly with the transmitter
+
.
If the light goes Red, the battery is low and operation
may stop within the hour. If the receiver’s light is half Red
and half Green the receiver is not paired with the
transmitter, and the receiver uses its interenal
microphone. To restore the connection between
transmitter and receiver, press the power button on the
transmitter twice (OFF then ON).
5. To use
The Conversor Pro Receiver on its own
The Conversor Pro Receiver has an onboard
microphone which enables it to be used as an Assistive
Listening Device without the Transmitter. To use in this
mode, turn on only the Receiver.
+
When the receiver is too far away from the transmitter, the receiver
automatically switches to the onboard microphone. The transmitter
has range of approximately 20 metres.
* Volume Memory — The Conversor Pro Receiver automatically
stores the most recent volume level selected before the unit was
switched off. This level remains selected until a new level is chosen.
Each level is indicated by a “beep” when the volume control is
pressed. When the top of the volume range is reached a higher pitch
“beep” can be heard.
1. To adjust the volume
between high and low
select the button to
increase the volume.
2. To adjust the volume*
between high and low
select the button to
decrease the volume.
3. Switch the Receiver
ON/OFF by pressing the
bottom button
4. Independent Microphone
35918®Conversor Pro User Guide UK 16/9/08 10:48 Page 8