f^PYL
or FAS
f
300 volts
approved.
B - Black
G - Green
R - Red
C - Copper
P (PW) - Purple
B - Black
G - Green
R - Red
C - Copper
P (PW) - Purple
R
R
B
B
C
PO
WER
G
P
*
CANADA
WITH the use pilot wire (PW)
R
R
DEVICE
B
B
C
P
G
CANADA
WITHOUT the use pilot wire (PW)
DEVICE
PO
WER
CONVECTAIR recommends that your heater be installed by a
X\HSPȹLKLSLJ[YPJPHUHUKPUHJJVYKHUJL^P[OUH[PVUHSHUKSVJHS
codes.
This heater must be connected to a 240 Volt (60 cycles) circuit
and with an appropriate breaker. Cut all electrical current
before connecting the heater to avoid shocks and damages to
the unit.
;OLȹYZ[[PTL`V\Y*VU]LJ[HPYOLH[ZHSPNO[ZTVRLJV\SKIL
released due to the burning of production residues. This is
normal and should disappear after 2 to 3 minutes.
WARNING:
To prevent short circuits and electrical shocks
[\YU[OLWV^LYVȸH[[OLTHPUWHULSILMVYLH[[LTW[PUN[OL
installation or making any repairs. This programmer system is
old technology and will not work on this new generation.
- You must connect the ground wire of the heater (green wire)
with the copper wire.
- Connect the power cables to the red and black cables.
- Never connect the pilot-wire (purple wire) to the electrical
supply nor ground it.
- The purple wire with the seal at the extremity should not be
used for the electrical connection. It is used only if the heater is
connected with other CONVECTAIR units for synchronisation of
heating schedule and temperatures.
- Fix the unit on the wall bracket before turning the power
back on.
3.
C
O
NNECTION
MEASURES T
O
BE T
A
KEN
