8.
4
electrical connection
RESpEcT WiRE coloR WiRiNG
-You must connect the ground wire of the heater (green
wire
)
with the copper wire.
-The purple wire with the seal at the extremity should
not be used for the electrical connection.
-The purple wire is used only if the heater is connected
with the
coNVEcTAiR
central programming system.
-
coNVEcTAiR
recommends that your heater be installed by a qualified
electrician and in accordance with national and local codes.
-This heater must be connected to a 240 volt (60 cycles) circuit.
Disconnect the power supply before making wiring connections
to prevent electrical shock and equipement damage. If you are using
a programmer system, make sur to cut the power off ALL electrical
heating circuits in the home
-The connection of the heater must be done inside the inner box
on the left side of the control panel. Connect the wires using the wire
connectors provided in the bag (fig.9)
-To prevent short circuits and electrical shocks turn the power off
at the main panel before attempting the installation or making
any repairs.
-If the power cable is damaged it must be replaced by the manufacturer,
an approved service depot or a technician with similar qualifications to
avoid any danger.
!
Fig.9
