2.
7.
1 - OVERVIEW
Introduction: We thank you for choosing Convectair’s premium electric heating products and
we congratulate you on the purchase of this Programmer. To obtain the best results and the ul-
timate in performance and comfort, please take a moment to read the installation and operation
instructions detailed in this manual.
• This programmer can be used on heaters fi tted with a compatible receptacle.
- For a list of compatible heaters visit www.convectair.com/install
• The digital screen display allows you:
- to visualize the time, the day, the current heating status (comfort, economy or frost-pro-
tection), and the current program on an hour by hour basis;
- to set the time, the day, a program or confi rm a selection.
• Technical features:
- Tension: 240 V
- After a complete charge, the battery supply will last for a full 24 hours.
• Programmer settings:
- Comfort (room temperature as set on the heater)
- Economy (setback a desired amount of degrees from the Comfort settings, for short
absences or night time)
- Frost-protection (maintains a minimum of 7°C or 46°F for prolonged absences)
• The Programmer module can control up to 20 other Convectair heaters.
- While charging (20 minutes), Comfort is the only signal that can be sent
on the pilot wire.
In case the electric supply is cut for more than 24 hours, the programs are saved but time and day
are lost and should be set again. The screen displays a fl ashing 00:00. After charging for 20 minutes,
the heater will be operating according to Monday’s program at 00:00 AM (until the day and time are
reset).
5 - WARNINGS
Manual override:
It’s possible to override the heating status without touching the Programmer module. On the heater,
select another heating position:
- Comfort
- Economy
- Frost-protection
- Stop
When the Programmer module controls a number of heaters through the pilot wire, this procedure
enables the occupant to override an individual heater while the rest operates according to the current
program.
To return to the programmed settings, switch back to the Prog position .
- Should the back light not activate, leave the cassette programmer in the slot
to charge.
- When the cassette is not in the slot, the screen may switch off after a while.
Press on any button in order to re-activate. If light does not come back, insert
the cassette programmer into the slot.
IMPORT
ANT
:
IMPORT
ANT
:
- To plan your installation and connect heaters to this Programmer visit
www.convectair.com/install
- When the Programmer stays without power for a long period,
reset the time and day.
- The pilot wire must NOT be grounded.
- This Programmer module needs to be charged for 20 minutes, in the slot located on
the control panel of the heater, prior to its fi rst use. After a complete charge, the battery
supply will last for a full 24 hours.
- The Programmer module can be programmed when inserted into the heater or out of the
control panel slot, when fully charged.
- Prior to use, make sure you remove the protective fi lm that covers the display and the
Quick Reference Guide located on the Programmer module.