11.
OVERHEAT CONTROL
This heater is equipped with an automatic reset overheat protection. In case of a mal-
function of the unit (blocked air output or intake), the heater will stop heating automati-
cally.
To reset the heater :
Check that the front panel, top and bottom of the heater are free of obstruction. Once
the obstruction is removed and the heater cools down, the overheat control will reset
automatically.
13
MAINTENANCE
To keep your CONVECTAIR unit clean, regular maintenance is suggested. To remove
dust, use a soft cloth. To remove a stain, use a damp cloth.
)RUDEHWWHUSHUIRUPDQFHDQGPD[LPXPHႈFLHQF\LWLVVXJJHVWHGWKDWGXVWDQGOLQWEH
regularly removed from the protective louvers situated in front of your APÉRO.
NEVER USE ABRASIVE OR ACETONE-BASED PRODUCTS TO CLEAN YOUR
HEATER AS THIS MAY DETERIORATE THE EPOXY FINISH.
ANY REPAIR ON YOUR CONVECTAIR HEATER SHOULD ONLY BE DONE
BY A QUALIFIED TECHNICIAN, AND ONLY AFTER THE HEATER HAS BEEN
DISCONNECTED.
Recommendations and advice
Your CONVECTAIR heater will become hot when in use. Caution is advised when young children are
present.
'RQRWLQVHUWVPDOOREMHFWVLQWKHKHDWHUWKLVFRXOGFDXVHDQHOHFWULFDOVKRUWFLUFXLW¿UHRUGDPDJHWRWKH
inner components.
$Q\XVHRUPRGL¿FDWLRQVQRWDSSURYHGE\&219(&7$,5PD\FDXVHHOHFWULFDOVKRUWFLUFXLWV¿UHRULQMXULHV
to the users.
In certain cases, it is possible for yellowing of the surface to occur over time. This is not due to a
manufacturing defect.This is caused by surrounding air, which may contain smoke or dust, being heated
and circulated through the heater. This is particularly the case with ''white'' heaters and may translate in an
important important coloring of the unit.
Prevention : it is suggested that surfaces be frequently cleaned especially with units installed in
EDWKURRPVNLWFKHQVORFDWLRQVZKHUHFLJDUHWWHVPRNHLVSUHVHQWURRPVZLWKD¿UHSODFHRUZRRG
stove. Never use this heater during construction work or other activities that generate a lot of dust.
6
7
