Push the heater back onto the 2 top wall
bracket tabs, ensuring they
‘
click
’
into
the rear panel slots (Fig 8). Tighten the
2 screws to lock the bracket into place.
•
Remove the battery protector tab (Fig
9).
•
When the heater
’
s power is on, the
remote control can be used to operate
the heater from up to 6m away.
Note: if there are two or more heaters
within this distance, both will be
operated by the same remote control.
Remote Control Setup
Heater operation
To use the THERMOSTAT:-
•
Activate the heater for use by
pressing the
“
ON/OFF
”
remote isolate
button on the unit (see Fig 9). The
heater will
‘
beep
’
and the room
temperature will be displayed on the
LED display.
•
Turn the heater ON by pressing the
“
ON/OFF
”
button on the unit or the
remote control. Press the
“
MODE
”
button on the unit or the remote control
to change the heat setting from LO
(1000W heating) to HI (2000W).
•
Turn the heater OFF by pressing the
“
ON/OFF
”
button at any time.
Your heater will operate most efficiently
when utilising the thermostat to turn
your heater off when your desired heat
setting is reached. To operate your
thermostat:
•
Press the
“
MODE
”
button on the unit
or remote control to select
“
AUTO
”
setting.
•
Select the temperature setting you
want by pressing the
“
TEMP
”
button on
the unit or remote. You can select in the
range of 5°-35°C.
•
When the room temperature is
below the selected set temperature, the
unit will heat the room. If the room is
above the set temperature, the heat
element will turn off.
Do not set the thermostat
temperature too high. This will consume
more power. 23°C is the recommended
set temperature.
The TIMER function can be used to turn
the heater OFF automatically.
•
Press the
“
TIMER
”
button on the unit
or remote control -
“
0.0
”
and
symbol
will appear on the display.
•
Continually press the
“
TIMER
”
button
to adjust the set time by 0.5 hr
increments up to 8 hrs. You can change
the time remaining at any point by
repeating the above steps.
•
Leave at the desired time. The timer
will begin to count down until the heater
turns itself off.
•
To cancel the timer, set the time to
“
0.0
”
.
The
symbol will no longer be lit.
Tip !
To use the TIMER function:-
To maximise the efficiency of the heater,
clean the inlet and outlet grilles
regularly.
•
Unplug the heater from the mains
power supply before cleaning.
•
Use a soft, damp cloth to wipe the
outside. Never use thinners or other
strong chemicals on the heater
surfaces.
•
Use a vacuum cleaner to remove dirt
and dust from the back panel vent slots.
•
Ensure the heater is dry before
plugging back into the mains power
supply.
®
4
SEELEY INTERNATIONAL
–
OWNER
’
S MANUAL
5
OPERATION
cont.
MAINTENANCE
CPH Series Portable Heaters
ASSEMBLY
cont.
OPERATION
8
9
REMOTE CONTROL
HEATER CONTROLS
HEATER DISPLAY
POWER
ON/OFF
BATTERY
PROTECTOR
TAB
MODE
SELECT
PULL THIS TAB
TIMER
ADJUST
TEMP
ADJUST
MODE SETTING
ROOM TEMP/
SET TEMP/
TIMER SETTING
TIMER
INDICATOR
TIMER
ON/OFF
TEMP
MODE
REMOTE
ISOLATE
BUTTON
TIMER
ON/OFF
ON
OFF
TEMP
MODE
