Convair ClimateMaster CP9RW, Инструкция по эксплуатации

Страница: 8 / 16

High Up Auto
Down Cool
Fan
Power Timer
°C °F
Low
8
If there are two of the same air
conditioners installed, they cannot be
controlled separately. When you operate
either remote, it will turn on both air
conditioners if they are both within signal
range (6 metres).
Don’t let the remote control drop onto hard
surfaces or be subjected to sudden
shocks in any way. The warranty does not
cover misuse or accidental damage.
Don’t place the remote control in direct
sunlight, or near extremes of temperature.
This will affect the control’s temperature
reading.
Don’t allow the remote control to get wet.
Don’t place near strong electromagnetic
waves.
Don’t mix old and new batteries ! If the
remote control will not be used for a long
time, remove the batteries to avoid
corrosion.
Care of your remote control
Preparation before operation
During Operation
Remove the battery cover and insert new
batteries
.
Remove the batteries and replace with new
ones. If this does not solve the problem
contact your nearest service centre for
advice.
(AAA), making sure the + and -
are matching the compartment markings
(Fig 9)
If the remote control will not operate the air
conditioner, the batteries may need to be
replaced.
The air conditioner must be plugged
in and switched on for the remote control to
operate the air conditioner. To use, point at
the signal receiving window on the front
panel and press the remote button. The air
conditioner will “beep” when a signal has
been received. If there is no beep, press
the remote button again, ensuring it is
within range (6 metres) of the air
conditioner.
Note!
!
NOTE:
WASTE BATTERIES SHOULD
BE DISPOSED OF CORRECTLY
Signal
transmission point
Temperature /
Timer adjust button
Timer button
Fan Speed
Adjust Buttons
Mode buttons
(Auto-Cool-Fan)
°C / °F toggle
button
Power ON / OFF
button
Battery
compartment
Battery cover
9
REMOTE CONTROL
6