Convair ClimateMaster CM15RCS, Инструкция по эксплуатации

Страница: 9 / 16

Starting the air conditioner
Step 1: Ensure the cooler is plugged in
and switched on.
Step 2:
Step 3:
Heat mode
Cooling mode
Fan mode
Step 4:
!
Step 5:
Press the ON/OFF button on the
remote control or ON/OFF button on the
control panel to start the air conditioner.
Press the MODE button o n
the control panel or remote control to
select the desired operating mode (Fig. 7
&11):
- reverse cycle
heating (CM15RCS only)
- refrigerated
cooling
- Fan only operation
(no cooling)
Press / on the control panel
or on the remote control to select the
desired operating ‘set’ temperature.
In Cooling mode, cooling will occur if the
set temperature is less than the room
temperature.
In Heating mode, heating will occur if the
set temperature is greater than the room
temperature.
Do not set the cooling temperature too
low. This will consume more power. 24°C
is the recommended set temperature, with
high fan speed.
Changing the set temperature will
have no effect in FAN mode.
Press the FAN SPEED button
on the control panel or remote control to
adjust the fan speed. Each press will cycle
the fan speed through low, medium & high.
In Cooling & Heating modes, the fan
will continue to run even when the
compressor has cycled off.
r s
The set temperature range is 16°C-31°C
Tip
Note!
Note!
Important! During heating mode the unit
may enter a defrost cycle. When this
occurs, the compressor will stop and the
fan will continue to run. This is a normal
function for all reverse cycle air
conditioners. The compressor will re-start
and normal heating operation will
recommence
when the defrost cycle is
complete.
During cooling and heating mode, water
will collect in the air conditioner’s tank. In
cooling mode this water is recirculated and
some will be exhausted out with the hot air,
but will slowly fill up the tank. This occurs
more quickly in humid conditions. There is
no recirculation in heating mode.
If the
tank should fill, the ‘water full’ symbol
will flash on the control display, the unit will
‘beep’ 15 times and then shut down. The
cooler cannot be restarted until the water
tank is drained. Refer to the Maintenance
section for draining the tank should this
occur.
Step.2
Step.8
Step.3 Step.5
Step.4
Step.7
Step.6
OPERATION
7
11