Convair ClimateMaster CM15RCS, Инструкция по эксплуатации

Страница: 10 / 16

D
B
OPERATION
8
Air Conditioner Features
Step 6:
Step 7:
Timer Function
Step 8: Setting the timer
Your air conditioner has a SLEEP
mode, activated by pressing the button on
the control panel or remote control.
SLEEP mode will change the fan speed to
low and increase (for cooling mode) or
decrease (for heating mode) the set
temperature by 1°C each hour for 2 hours.
No further change will occur after the 2nd
hour.
To improve air cleanliness, your
cooler is equipped with an active carbon
filter, negative ion generator and TiO lamp.
Fit the active carbon filter into the upper
rear filter frame as shown (Fig 12).
A - remove side filter from unit
B - remove upper rear filter
C - unclip the frame from the rear filter
D - insert the active carbon filter and clip
the frame back into place.
Reassemble all filters back into the unit,
then press the Ion/TiO button on the
control panel or remote control to activate
this feature.
The air conditioner is fitted with a timer
function. This can be set up to 24 hours
in advance. To use this function, the
cooler must be plugged in and ready to
operate.
With the air conditioner ON, press the
TIMER button on the remote control or
control panel. The control panel display
will flash and show the time setting. Press
the TIMER button to increase the time in 1
hour increments from 1 - 24 hrs. After 5
seconds the display will revert to the SET
temperature.
2
2
12
A
C
When the air conditioner is OFF (but still
plugged in), repeat the above to set the
ON time. The air conditioner will start up
with the last settings used.
When the air conditioner is
working, only the TIMER OFF can be set.
When the air conditioner is off, only the
TIMER ON can be set.
To cancel the timer, press and hold the
TIMER button on the control panel for 3
seconds or set the time to
using the
remote control. The TIMER indicator will
stop glowing.
Note!
How to cancel the timer
0