CONTROLS, INCORPORATED
C O N T R O L S Y S T E M S & S O L U T I O N S
- 2 -
PANEL OPERATION
MANUAL OPERATION
1)
Engine Start - Turn key to CRANK position
2)
Engine Stop - Turn key to OFF position
AUTO START/STOP OPERATION
1)
Engine Start - Turn key to AUTO position
Engine start/stop based on auto start/stop settings. Panel display shows “Auto Start ARMED”
message. The engine starts when the remote start input wire is grounded. The engine stops
when the remote start wire is not grounded.
SLEEP MODE
To minimize current draw, the panel goes into a sleep mode two minutes after being set in auto
mode. In sleep mode, the display goes blank and the red lamp blinks once every ten seconds. The
engine ECU is also turned off.
Upon receiving a signal from a float or transducer the panel wakes up, the display turns back on and
normal operation commences.
Pushing any of the four buttons wakes up the panel and turns the display on. It will return to sleep
mode after a two minute period.
For service purposes, to keep the engine ECU powered, access the menu system. The engine ECU
remains on when the menu system is active.
