The performances stated in this sheet can be modifi ed without any prior notice
NR9000-RX RECEIVER MODULE
For operation with remote control NR9000-TC it is necessary to con-
nect the receiver module NR9000-RX to the controller NR9000 through
the flat cable supplied with it using the connection port placed on
the upper side of the controller.
The receiver module is equipped with 2 signalling LEDs:
•
GREEN LED to show the controller status (LED ON = controller ON,
LED OFF = controller OFF);
•
YELLOW LED to show the time table status (LED ON = time table
enabled, LED OFF = time table disabled).
The GREEN and YELLOW LED briefly blink when they receive a signal
coming from the remote control.
Further than the two LEDs the receiver module is equipped with a
button to override the switching on and switching off of the con
-
troller. If time table are enabled, by pressing the button they will be
disabled.
NR9000-RX infrared receiver module mounting instructions
The receiver module is supplied together with a flat connector
(80cm) to be connected to NR9000 controller and a double-side
tape for fixing on smooth surfaces.
In case the flat cable is not connected to the receiver, proceed as
follows:
1.
unscrew the two screws on the receiver to open the back cov
-
er: a 6-terminal connector will be visible;
2. insert one end of the cable inside the connector. The connector
can be mounted in one direction only as it is polarized;
3.
close again the back cover and tighten the screws making the
flat cable come out from the split you find between cover and
case;
4.
in case it is necessary to place the flat cable in a duct, see the
picture below for duct dimensions;
5.
connect the other end of the flat cable to the connector you
can see in the split on the upper side of the controller. The con-
nector can be mounted in one direction only as the cable is
polarized;
6.
Place the double-side tape on the back side of the receiver
module and pay attention not to force the flat cable.
N.B.: In case the flat cable is already connected to the receiver
module, just follow the instructions on point 5 and 6.
4,25
13,8
14,3
DIMENSIONS [mm]
NR9000
NR9000-RT1X
NR9000-RT2X
134
136,5
44
42,5
36,3
22,4
50,4
30
NR9000-TC
50
35
20
NR9000-RX
1
st
Issue rev. c
12/2015
DBL408e
Page 18
