Existing 0-10V - 24V actuator
(by different brands) is usually
connected by default to an
existing BMS or control system.
Power off the incoming 24V
and disconnect the wires from
the BMS.
Add lables to each wire, as
often colors are only indicative.
Start from the OUT cable, and
connect the eNode with the
existing actuator.
Continue with the IN cable, and
connect the eNode with the
BMS and 24V power supply.
Press the power button all the
way down.
The eNode will start to power
on.
Only after 30-40 seconds,
the LED will switch on
.
Secure the eNode to a good and
protected location using zip-ties
or strong tape.
Disconnect existing
actuator from BMS
NOTES
Power supply must have a
protection installed to prevent
overloading and must be limited
to a maximum of 100W.
Installation must be performed
by a certified electrician
Connect the eNode
with the actuator
Connect the eNode
with BMS & 24V
Power on the
eNode
Fix the eNode on a
firm surface
INSTALLATION IS
NOW COMPLETE!
1
2
3
4
5
4
2
3
1
1
st
Issue
11/19
3
DIM
309
e
