8
Unidrive M100/M101/M200/M201/M300 Step By Step Guide
Issue Number: 1
Table 10-1 Status indications
STEP 11: Understand key parameters and restoring default
When changing a parameter, the new value is saved when pressing the Enter button to return to parameter view
mode from parameter edit mode.
Restoring default parameters:
1.
Ensure the drive is not enabled, i.e. terminal 11 (or terminal 31 and 34 on Unidrive M300) is open.
2.
Select 'Def.50 (50 Hz settings) or Def.60 (60 Hz settings)’ in Pr
00
.
3.
Press the red reset button
String
Description
Drive output
stage
inh
The drive is inhibited and cannot be run. The Drive Enable signal is not applied
to the drive enable terminal or is set to 0.
Disabled
rdy
The drive is ready to run. The drive enable is active, but the drive inverter is
not active because the final drive run is not active
Disabled
StoP
The drive is stopped / holding zero speed.
Enabled
S.Loss
Supply loss condition has been detected
Enabled
dc inj
The drive is applying dc injection braking
Enabled
Er
The drive has tripped and no longer controlling the motor. The trip code
appears on the display.
Disabled
UV
The drive is in the under voltage state.
Disabled
Parameter
Range (
Ú
)
Default (
Ö
)
01
Minimum Speed
0.00 to Pr
02
Hz
0.00 Hz
02
Maximum Speed
0.00 to 550.00 Hz
Def.50: 50.00 Hz
Def.60: 60.00 Hz
03
Acceleration Rate 1
0.0 to 32000.0 s/100 Hz
5.0 s/100 Hz
04
Deceleration Rate 1
0.0 to 32000.0 s/100 Hz
10.0 s/100 Hz
05
Drive Configuration
Refer to the
Quick Start Guide
for further
information on all drive configurations
M100/M200/M300: AV
M101/M201: PAd
06
Motor Rated Current
0.00 to Drive Rating Amps
Maximum Heavy Duty
Rating Amps
07
Motor Rated Speed
0.0 to 33000.0 rpm
Def.50: 1500.0 rpm
Def.60: 1800.0 rpm
08
Motor Rated Voltage
0 to 240 V or 0 to 480 V
110V drive: 230 V
200V drive: 230 V
400V drive Def.50: 400 V
400V drive Def.60: 460 V
09
Motor Rated Power Factor
0.00 to 1.00
0.85
10
User Security Status
Refer to the
Quick Start Guide
for further
information
LEVEL.1
