Control Techniques 0477-0008-01, Руководство пользователя

Страница: 6 / 60

6
DeviceNet Module User Guide
www.controltechniques.com Issue 1
3.2 Connections
Figure 3-2 DeviceNet Module connections
Digistart CS Digistart IS
08647.
A
1
2
3
V -
CA
N_
L
S
h
ie
ld
CA
N_
H
V +
08648.
A
1
2
3
V -
CA
N_
L
S
h
ie
ld
CA
N_
H
V +
Digistart CS Digistart IS (Remote mode)
DeviceNet Module DI2, +24V: Stop
Standard connection onto DeviceNet network DI3, +24V: Reset
DeviceNet Module
Standard connection onto DeviceNet network
For the DeviceNet Module to accept serial commands, a link must be fitted across terminals CSL-DI2 on Digistart CS starters.
Input links are required across terminals DI2, +24V and DI3, +24V if the Digistart IS soft starter is being operated in Remote mode. In
Local mode, links are not required.
NOTE
Digistart IS Pr
3O Comms in Remote selects whether the soft starter will accept Start, Stop or Reset commands from the
Serial Network Master while in Remote mode. See the Digistart IS User Manual for parameter details.
3.3 Module and network LEDs
The Module LED indicates the condition of the power supply and module operation.
The Network LED indicates status of the communication link between the DeviceNet Module and the network Master.
Figure 3-3 Feedback LEDs
1
2
LED State Description
(Module)
Off Network power off
Green Normal operation
Red Unrecoverable fault
Red/Green flashing Self Test mode
(Network)
Off Duplicate MAC ID test has not been completed
Green flashing Online but no connection with Master
Green Online and allocated to a Master
Red flashing One or more timed out I/O connections
Red Failed communication between module and Master
Red/Green flashing Communication faulted and received an Identity communication
faulted request
NOTE
When a communications failure occurs, the soft starter may trip if the Communication Timeout parameter for the network is
set greater than zero. When communication is restored, the soft starter must be reset.