4
TROUBLE SHOOTING
Follow these steps:
Make sure the LED is lit when the receiver power is turns on. If the LED is not on, check your
power supply to the receiver.
With the receiver powered up, make sure the LED comes on when the buttons are depressed on
the key fob. If the LED does not come on the receiver is not getting a signal from the transmitter.
If the battery in the transmitter is more than 2-3 years old check battery voltage with a meter or
replace battery.
After completing the above steps and the unit still will not function, follow the procedure,
Set-up
of Key fob to Receiver Address
.
If the unit still will not operate. Check connections to the component that the unit is trying to
actuate using a voltmeter.
If the transmitter was allowed to freeze, warm up before using.
Check all connections and make sure you have a clean power and ground.
Check the fuse.
Diagnose any problems with what the unit is connected to.
Other Considerations
Only one transmitter at a time can be activated within a reception area. Only one carrier of a particular
frequency may occupy the same airspace at a given time. This means that if two transmitters are activated
in the same area at the same time the signals will interfere and the decoder on the receiver will not see a
valid transmission and the unit will not function. Also, CAW has no control over the intended usage of
this product. Because of that CAW offers no written or expressed liability as to how this product is used.
CAW recommends that these units are intended for
OFF ROAD USE ONLY
Limited warranty on electronics see wireless warranty on the website for details
Содержание 4DP2L0EFA
Страница 2: ...2 FIGURE 1 S1 S4 S3 S2...
