Option 5: WiFi Connection with DC Power
This option sets up WiFi and DC power.
Ensure that you have WiFi in the home.
NOTE:
WiFi requires an antenna (sold
separately).
To install the Door Station with WiFi and DC power:
1
Connect the negative (-) and positive (+) wires
to the DC power source for the Door Station
according to the national and local electrical
codes.
NOTE
: The positive (+) wire’s connector is
located on the bottom left side of the Door
Station’s plate.
2
Your installation may require alternative wires and
the use of a terminal block. Strip the power wires
to 1/4” on the end if necessary.
3
Attach the antenna (3m or 26cm) to the Door
Station. See “WiFi Antenna Kit Installation” for
details.
4
Run the antenna wire through the back box hole
(see Figure 12). Ensure that the wire doesn’t
touch the back box.
5
Align the antenna vertically to the wall outside
the back box (26cm antenna) or run the antenna
through the wall (3m antenna).
Figure 7. WiFi with DC Power
Option 6: WiFi Connection with PoE
This option sets up WiFi and PoE.
Ensure that you have WiFi in the home.
NOTE:
WiFi requires an antenna (sold
separately).
To install the Door Station with WiFi and PoE:
1
Plug the Ethernet cable into the Door Station
(see Figure 8).
2
Attach the antenna (3m or 26cm) to the Door
Station. See “WiFi Antenna Kit Installation” for
details.
3
Run the antenna wire through the back box hole
(see Figure 12). Ensure that the wire doesn’t
touch the back box.
4
Align the antenna vertically to the wall outside
the back box (26cm antenna) or run the antenna
through the wall (3m antenna).
6
DC Connections
(Hot and Load)
Antenna
