EMM-µD3h EMM-µD3h-p EMM-µD3h-485 instruction manual
IM380-U v3.1
pag. 7 / 12
CANCELLING OF THE PEAK VALUES AND ENERGY METERS (
)
From the measures visualisation mode, keep the
A
key pressed until the message
appears on the
C
display;
then press the
B
key until the message
appears on the
C
display; access to the reset menu by pressing the
A
key. By pressing the same key we can now select the cancellation type that we wish to activate.
Here below the different types:
cancellation of the instantaneous values only
cancellation of the average values in the 15’ only
cancellation of the energy meters
cancellation of the energy meters, average and the instantaneous values.
To activate the selected cancellation mode, press the
B
key to change the
C
display’s indication from
to
.
Confirm to activate the cancellation, by pressing the
A
key; the indication in the display
C
will pass from
to
Without pressing any key, wait until the instrument returns to the measures visualisation mode.
PROGRAMMING THE DIGITAL OUTPUT (
)
(only
for EMM-µD3h-p)
In the menu
and
it’s possible to program the function of all digital outputs. In these menus are
available the following modality:
and
(alarm).
In
mode the digital output DO1 will emit pulses proportional to the active energy counted while the digital output
DO2 will emit pulses proportional to the reactive energy counted. The proportionality will depend from the
set in
the
and the duration of the impulse is set in the
voice of the
.
In
mode there are three settings
,
for the three-phase connection and
for the single phase connection. With
the digital output works as alarm verifying that the (average)
three-phase value
doesn’t exceed the thresholds set (
and
). With
and
the digital output works as alarm verifying that the maximum value of the single phase
doesn’t exceed the maximum
threshold set (
) and that the minimum value of the single phase is below the minimum threshold set. With
it’s possible to activate the digital output after a delay expressed in seconds.
If only
threshold is set, alarm act as “maximum value” function; If only
threshold is set, alarm act as
“minimum value” function; if both thresholds are set, alarm works as “BAND” function.
Access to the menu:
Selecting the pulse type
or alarm
(with
=
and
)
(with
=
and
)
(only with
=
)
Selecting the alarm
parameter
(see list)
(not usable for
)
(not usable for
)
Set maximum alarm threshold
Increase
Decrease
(after there is
)
Set minimum alarm threshold
Increase
Decrease
(after there is
)
Set delay
Increase
Decrease
Confirm and end of digital output configuration.
