STEP 9 Glazing the Vinyl into the
In-Line Panel
1. Remove the 2
″
strips of temporary Vertical Press-In
Vinyl (#18) and shift In-Line Glass Panel (#25) to obtain
sufficient overlap along both horizontal and vertical edges.
2. Push in the Horizontal Press-In Vinyl (large profile) (#17)
from the outside between the glass and the Bottom Curb/Sill
(#2) and Header (#1).This task is made easier by using a
pen (as shown in Figure 12) to push the vinyl into Bottom
Curb/Sill (#2) and Header (#1). Cut square covering the
full width of the panel opening. Push the Vertical Press-In
Vinyl (small profile) (#19) from the outside between the Wall
Jamb (#6) and the Insert Jamb (#3).
STEP 10 Silicone Sealing the Enclosure
1. Using the Clear Tub/Tile Silicone, seal all edges inside
and outside where curb or walls meet the horizontal or
vertical Jambs.
2. Standing inside the enclosure, seal the In-Line Glass
Panel (#25), on the side and along the Bottom Curb/Sill
(#2) (See Figure 13).
3. CW
®
uses the “Wet Glaze” technique to secure the In-
Line Glass Panel (#26) on the inside of the unit. Run the
Clear Tub/Tile Silicone in between the glass and metal,
around the entire inside perimeter (See Figures 14A and
14B). Follow manufacturer’s instructions for the sealant.
Sealant must cure for 24 hours before using shower.
6
I06000H-180-0704
Figure 12
Figure 13
Figure 14A
Figure 14B
STEP 11 Installing the Drip Rail
1. With a pair of scissors cut the clear Drip Rail Gasket
(#12) 2
″
longer than the Drip Rail (#11). Cut a notch into
the strike side of the Drip Rail Gasket (#12) (see Figure
15). Using a lubricant (such as CW
®
Glass Cleaner) (see
Figure 16) slide the Drip Rail Gasket (#12) into the smaller
channel in the Drip Rail (#11), allow
1/2
″
extra gasket on
the strike side (including the notch) (see Figure 17). With
Pliers, crimp both ends of the Drip Rail (#11) to secure the
Drip Rail Gasket (#12). There will be 1-1/2
″
overlap on the
door side of the Drip Rail Gasket (#12) (See Figure 18).
Figure 17
Figure 15
Figure 16
