Figure 13
5
STEP 6 Installing the Sill Spacer
1. Place the Sill Spacer (#15) into the groove of the
Header (#1).
STEP 7 Installing the Header and Snap-In
Pivot Strip
1. Place the Header (#1) over the vertical pieces of metal,
as shown in Figure 8.
2. Drill assembly holes with a 7/64
″
Drill Bit into the Header
(#1) through the Slip Jamb Male (#5) and Wall Jamb (#6).
Secure at the top, on both sides using #6 x 1/4
″
“B”-Point
Screws (#22) (See Figure 9).
3. Locate the Snap-In Pivot Strip (#14). Snap the Snap-In
Pivot Strip (#14) into the Header/Curb (#1). Repeat this for
the Header/Curb (#2) making sure the “raised” edge of the
Snap-In Pivot Strip (#14) is to the outside of the unit.
STEP 8 Installing and Adjusting the Door and
Insert Jamb
Installing the door panel may be easier if you have
someone to assist you.
1. Temporarily install the Framed Door with CW
®
Rotary
Gear Hinge Assembly with Magnetic Seal (#4) into the Slip
Jamb Male (#5). Mark and drill three installation holes. Insert
the top, #6 x 1/4
″
“B”-Point Screw (#22) only at this time
(See Figure 11). Make sure that the door is level. Secure the
CW
®
Rotary Gear Hinge Assembly (#4) into the Slip Jamb
Male (#5) with the remaining two #6 x 1/4
″
“B”-Point
Screws (#22).
Note: Magnetic Jamb Seal (#13) faces toward the outside
of the shower. Once installed, if you find that the door
will not stay closed, the magnet needs to be turned
around. Remove the Magnetic Jamb Seal (#13) from
the Insert Jamb (#3) and
reinsert it the other way.
2. Insert the two #8 x 1-1/2
″
FH SMS Screws (#24) into
the Inside Handle (with
Holes) (#10). Push the
screws through the Door
Panel and line up with the
Outside
Handle
(#9).
Tighten the screws. (See
Figure 11).
3. Insert the middle
#6 x 1/4
″
“B”-Point Screw
(#22) into the Slip Jamb
Male (#5). You may have
to flex the Slip Jamb Male
(#5) for proper clearance
once
the
door
handle
is
in
place.
4. Make sure that both the Door (#4) and the Insert Jamb
(#3) are level. Secure the Insert Jamb (#3) to the Header
(#1) with a #6 x 7/16
″
“B”-Point Screw (#23). Repeat this
step securing the Insert Jamb (#3) to the Bottom Curb/Sill
Figure 7
Figure 8
I06000H-180-0704
Figure 9
Figure 11
Figure 10
