Contractor 15205, Инструкция по эксплуатации

Страница: 15 / 120

ENGLISH
CONTRACOR
®
CAB-110P/CAB-135P Art. 15205/15206 15
ATTENTION!
Shut down the cabinet immediately if dust discharges from the collector.
Check that filters are correctly seated and not worn or damaged.
Prolonged breathing of any dust could result in serious lung disease
or death. Short term ingestion of toxic dust such as lead, poses an
immediate danger to health. Toxicity and health risk vary with dust
generated by blasting. Identify all material being removed by blasting, and
obtain a material safety data sheet for the media.
Turn on the compressed air supply to the blast cabinet. Inspect for air leaks during
the initial start up
Set the pulse pressure regulator to 4,5 bar (see Picture 2 for location).
Turn the on/off switch to t “I” to activate the lights and filter pulse cleaning.
Push the “ON” button to turn on the exhauster.
Put on the rubber gloves.
Grasp the blast nozzle firmly and step on the pedal. Blasting will start immediately.
Set blast pressure using the pilot regulator located on the control panel.
The pressure gauge on the control panel indicates the actual blast pressure.
Smooth, continuous strokes are the most effective blasting technique. The size of
the blast pattern is affected by the distance from the part. The nozzle is usually positioned
approximately 70 to 150mm from the surface of the part.
The dust collector pulsates automatically according to the timer settings while
the blast cabinet is in operation. Prolonged periods of blasting or dirty conditions may
necessitate an adjustment of the timer settings.
4.2.5 Stop blasting operation and shut-down
To stop blasting, remove pressure on the foot pedal.
Use the Air blow-off nozzle to blow media off cleaned parts. Allow the exhauster to
clean the cabinet of airborne dust before opening the door and unload the parts.