36
W415-1338 / 07.09.14
EN
5.1
DO NOT CLEAN GLASS WHEN HOT! DO NOT USE
ABRASIVE CLEANERS TO CLEAN GLASS.
Buff lightly with a clean dry soft cloth. Clean both sides
of the glass after the
fi
rst 10 hours of operation with a
recommended
fi
replace glass cleaner. Thereafter clean
as required. If the glass is not kept clean permanent
discoloration and / or blemishes may result.
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
!
WARNING
10.3 CARE OF PLATED PARTS
37.1B
!
WARNING
THE FIREBOX BECOMES VERY HOT DURING OPERATION. LET THE APPLIANCE COOL
COMPLETELY OR WEAR HEAT RESISTANT GLOVES BEFORE CONDUCTING SERVICE.
NEVER VACUUM HOT EMBERS.
DO NOT PAINT THE PILOT ASSEMBLY.
•
This appliance will require maintenance which should be planned on an annual basis.
•
Service should include cleaning, battery replacement, venting inspection and inspection of the burner,
media and
fi
rebox. Refer to the door removal section and remove the door as instructed.
•
Carefully remove media if necessary (logs, glass, brick panels etc).
•
Using a vacuum with a soft brush attachment, gently remove any dirt, debris or carbon build up from the
logs,
fi
rebox and burner. For glass media, follow the installation instructions for pre-cleaning.
•
Also gently remove any build-up on the pilot assembly including, if equipped; thermopile, thermocouple,
fl
ame sensor and igniter.
NOTE: The fl ame sensor may require to be cleaned using a fi ne steel wool or
Scotch-Brite™ scrubbing pad to remove any oxides. Clean the pilot assembly using a vacuum with a
soft brush attachment. It is important that the pilot assembly is not painted.
•
Inspect all accessible gaskets and replace as required.
•
Access the blower, if equipped and clean using a soft brush and vacuum.
•
Re-assemble the various components in reverse order.
•
Inspect the relief system. The appliance relieves through the main glass door or through the
fl
aps on the
fi
rebox top. Ensure they open freely, and close sealed.
6.1
If the appliance is equipped with plated parts, you must clean
fi
ngerprints or other marks from the plated
surfaces before operating the appliance for the
fi
rst time. Use a glass cleaner or vinegar and towel to clean.
If not cleaned properly before operating for the
fi
rst time, the marks can cause permanent blemishes on
the plating. After the plating is cured, the
fi
ngerprints and oils will not affect the
fi
nish and little maintenance
is required, just wipe clean as needed. Prolonged high temperature burning with the door ajar may cause
discolouration on plated parts.
NOTE: The protective wrap on plated parts is best removed when the assembly is at room
temperature but this can be improved if the assembly is warmed, using a hair dryer or similar heat
source.
10.1 ANNUAL MAINTENANCE
10.2 CARE OF GLASS
5.5.1
This appliance is factory equipped with 5mm ceramic glass. Use only replacement glass available from your
Napoleon® dealer. DO NOT SUBSTITUTE MATERIALS.
Содержание CWHD31N
