Conti CAG-113, Руководство пользователя

Страница: 36 / 64

BUILT-IN HOB
ENVIRONMENTAL WARNING:
If the device after
installation, packaging materials, showingthe importance of safety
and environmental conditions need to throw it away. According tothe
properties for re-use of waste packaging (foil, cardboard, styrofoam,
etc.) Before throwing away the product by cutting the power cord is
not used for children are not exposed to danger and drape.
WARNING:
The use of a gas cooking appliance results in the production of heat and moisture in the
room in which is installed. Ensure that the kitchen is well ventilated: keep natural ventilation
holes open or install a mechanical ventilation device (mechanical extractor hood)
Prolonged intensive use of the appliance may call for additional ventilation, for example opening of a
window or more effective ventilation, for exrample increasing the level of mechanical ventilation where
present.
Need to do when there is gas odor
• Turn off all valves on the gas products and gas meters.
• Do not use naked flames or smoke.
• Do not operate any electrical switch. (Eg lamp switch or the door bell)
• Open the doors and windows.
• Check all pipes and connections to leak or not. Still getting the smell of gas, exit the house.
Safety about Electrical Studies
• Any work done on electrical equipment and systems, performed by competent and qualified persons.
• Turn off and disconnect it from the product in case of any damage. To do this, turn off your home
insurance.
• Make sure it is compatible fuse current with product current.
INSTALLATION
This appliance shall be installed in accordance with the regulations in force and only used in a well
ventilated location. Read the instructions before installing or using this appliance.
WARNING:
Prior to installation, ensure that the local distribution conditions (nature of the gas and gas
pressure) and the adjustment of the appliance are compatible.
WARNING:
The adjustment conditions for this appliance are stated on the label (or data plate).
Installation should be carried out according to the instructions by a professionally qualified person. The
manufacturer will not accept responsibility for any damage to persons, animals or things due to wrong
installation..
Installation Instructions
• For installation the appliance must be connected in accordance with all local electrical regulations.
• Be sure to the gas and/or electrical installation is appropriate before calling the authorized service
provider of to make the product ready for use. If it is not, necessary arrangements must be done by
calling a licensed electrician or plumber. Then, call a qualified service.
• Product installation, the electric and / or gas rules should be specified in the relevant local standards.
Connection to the gas distribution system of the product should only be done by a qualified and
authorized person.
• The gas pressure and type that comes from the local gas distribution center, the data indicated on the
product nameplate or gas impression must be the same.
• The power cord avoid crush, fold and clamped or avoid contact with hot parts of product. After
installation, the plug must be easily accessible location.
• The hob has been designed to be fitted into a kitchen unit. It can be fitted either under a worktop or in
a taller cupboard unit at eye level. Cut out an opening in the kitchen unit as shown in. (See Figure 2
and Figure 3)
• The walls of the furnace is mounted must be heat resistant. In particular the side walls were made of
fiberboard coated. The coating resistant must be to 100 °C. This not heat-resistant synthetic laminates
and adhesives, plastics or adhesive materials may be damaged. This information will only be to create
a guide and the real resistance against the increase in temperature depends on the degree of kitchen
units and surface polish performance.
• Bench should be flattened and located horizontally.
• Cut the gap to be opened for hob over the bench according to the installation dimensions of the hob.
• While mounting the hob on a cabinet, a shelf should be mounted as illustrated in order to separate
between the cabinet and the hob. If it is mounted on a built-in oven, the distance should be at least
30mm. min.30 mm.