700W DMX Fog machine with Timer
Page 5
English
5 -Fan settings
Allows you to configure the fan speed.
6 - Power supply/Fuse holder:
The supplied cord features an IEC/2P+E connector.
Your unit is equipped with a 250V 4A fuse. If need to
replace it, use one with the same characteristics.
7 - ON/OFF Power switch
8 - DMX Inputs and outputs
3 and 5-pin XLR sockets allowing you to daisy-chain
more units.
9 - Fluid level
This window allows you to visualise the fluid level inside
the tank.
10 - Tank cap
Please make sure the cap is tightened to prevent any
leak or air entry.
11 - Transport handle
4 - DMX assignation:
Channel 1
DMX Value
Function
Smoke
0 - 4
Smoke OFF
5- 255
Smoke output from 0 to 100%
Channel 2
DMX Value
Function
Fan
0 - 4
Speed at 20%
5- 255
Speed from 21 to 100%
DMX Addressing
In order to use a DMX remote control with your FAZEtec, connect it to a DMX XLR socket.
When using long runs of cables (more than 100m), we strongly recommend to use a DMX end termination (120
Ohms resistor located between pins 2 and 3 of XLR plugs).
Each unit to be remotely controlled must have its own DMX address.
The address can lie between 0 and 511.
Configure dipswitches 1 to 9 for your devices to receive DMX signals. Refer to the table below for more information
about the relation between DMX addresses and the dipswitches binary code.
Dipswitches
#1
#2
#3
#4
#5
#6
#7
#8
#9
Decimal value
1
2
4
8
16
32
64
128
256
Your FAZEtec uses 2 DMX channels, in order to address several FAZEtec, you will be
required to address them as follows:
FAZEtec number 1 : address 1: activate dipswitch #1 (value 1)
FAZEtec number 2 : address 3: activate dipswitches #1 and #2 (value 1+2=3)
FAZEtec number 3 : address 5: activate dipswitches #1 and #3 (value 1+4=5)
etc ...
You can parameter dipswitches of two or more units on the same address so your units will all replicate the same
behaviour and answer the same commands.
256
128
64
32
16
8
4
2
1
