Contemporary Research ICC1-IR, Руководство по эксплуатации продукта

Страница: 10 / 23

Contemporary Research 10 ICC1-IR
Unit Address Settings
The unique address of the controller is the combination of the values of the Zone (S2) and Unit (S1) switches. For
example, the first controller in Zone 1 would be set to Zone 1 (256) in S2 and 1 (1) on S2, or 257. To control all
the displays in Zone one, Display Express sends a command to device 256. To control just the first unit, create a
Preset addressed to 257.
Installation Process and Documentation
Most dealers will pre-configure the controller’s address before hanging displays. After setting the address, use a
label that states the unit’s address and location. Some use this method:
Room 305 - 515 - 12/2
The first identifies the location/name of the display. The second shows the specific address. The last set shows the
switches in S1/S2 that are set to ON.
It’s a good idea to define all this first in a spreadsheet, with the columns defining the name, address, S1 and S2
ON settings. Then, one person can set up all the controllers and label them.
Once the controller is configured and labeled, it’s easier for less-trained installers to Velcro the controller on the
back of the display, provide power, and hang the displays.
It’s much easier to pre-configure ahead of time than perform the task once the displays are installed.
IR Control Wiring
1. Connect the CC-IRE IR Emitter plug into the IR Out jack.
2. Mount the emitter cube to the TV case where the TV receives IR commands.
3. Mount the ICC1-IR to the TV using included Velcro tape.
4. Connect DC power to unit.