Contec VPC-500P1, Руководство пользователя

Страница: 24 / 57

4. Each Component Function
VPC-500P1 Series User’s Manual
19
◆
Analog RGB Port Interface : ANALOG RGB
The product is equipped with 1 port for analog RGB interface.
Table 4.5 Analog RGB port connector
Connector type 15pin D-SUB connector (female)
Pin No. Signal name Pin No. Signal name
1 RED 9 VCC
2 GREEN 10 GND
3 BLUE 11 N.C.
4 N.C. 12 DDCDATA
5 GND 13 HSYNC
6 GND 14 VSYNC
7 GND 15 DDCCLK
8 GND
・
If the OS is booted without connecting the display cable, and then the display is connected after the
OS boots, the display may not be shown properly.
・
When the analog display is used, Windows MS-DOS may not be properly displayed in full-screen
mode. This is because the frequency and resolution of Windows and MS-DOS (full-screen display)
are the same due to the screen settings while the display parameters are different. For display, as
only one parameter can be stored for one frequency or resolution, only either of Windows or MS-
DOS screen can be displayed properly. In this case, change the resolution or display frequency of
Windows so that it is not the same as for the MS-DOS display.
・
When using a digital display, an analog display may be detected even though no analog display is
connected. This will not affect how the digital display appears. However, change the multi-display
settings as necessary.
・
To change the settings from digital output to analog output, change the settings from the standard
Windows properties screen.
5
1
11 15
10 6
No.4-40UNC
Inch screw
threads
CAUTION