Contec VPC-3000, Руководство пользователя

Страница: 12 / 125

１．
Introduction
User’s Manual
5
◆
Handling precautions
CAUTION indicates a potentially hazardous situation which, if not
avoided, may result in minor or moderate injury or in property
damage.
・
Do not use or store the product in a location exposed to extremely high or low temperature or
susceptible to rapid temperature changes.
Example
・
Exposure to direct sun
・
In the vicinity of a heat source
・
Do not use the product in extremely humid or dusty locations. It is extremely dangerous to use
the product with its interior penetrated by water or any other fluid or conductive dust. If the
product must be used in such an environment, install it on a dust-proof control panel, for
example.
・
Avoid using or storing the device in locations subject to shock or vibration.
・
Do not use the product in the vicinity of devices that generate strong magnetic force or noise.
Such devices will cause this device to malfunction.
・
Do not use or store the product in the presence of chemicals.
・
To clean, wipe it gently with a soft cloth dampened with either water or mild detergent.
Do not use chemicals or a volatile solvent, such as benzene or thinner, to prevent pealing,
discoloration of the paint, or deterioration of resin.
・
As continuous operation of the equipment may shorten the life of the hard disk drive, use it in
stand-by mode.
・
Be sure to unplug the power cable from a wall outlet before plugging or unplugging a extension
board or any connector.
・
CONTEC reserves the right to refuse to service a product modified by the user.
・
In the event of failure or abnormality (foul smells or excessive heat generation), unplug the
power cord immediately and contact your retailer.
・
Use an AC cable suitable for your supply voltage and outlet/plug. (The supplied cable is for
125V AC.
・
The hard disk must be replaced when the power of the main unit is off. It is not hot-swappable.
Removing the hard disk during operation may damage the system.
(However, hardware raid is excluded.)
・
Component Life:
(1)Power
･･････････････
During continuous operation at 40
℃
, the assumed life is about 4 years
(vertical installation). However, it may be shortened due to operating
temperature (high temperatures).
(2)Battery
･････････････
The internal calendar clock and CMOS RAM are backed by a Lithium
primary battery. The backup time at a temperature of 25°C with the
power disconnected is 7 years or more.
(3)CPU
・
Chassis FAN
･･･
During operation at 40
℃
, the assumed life is about 5 years.
However, it may be shortened due to operating temperature.
* Replacement of expendables is handled as a repair (there will be a charge).
・
To connect with peripherals, use a grounded, shielded cable.
・
Do not use a UPS (uninterruptible power supply) with square-wave output, as connecting it
may damage the system.
・
Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according
to the instructions.
・
Abandon a used battery appropriately according to the instruction of the municipality.