- 10 -
10. Reset
To reset your remote control to its factory default settings…
1. Press [S-A] (or [MOT]), then [SEL / OK] together until the [S-A] (or [MOT]) button illuminates.
2. Press [0]. The [S-A] (or [MOT]) button will blink 3 times and go out.
Reset returns the TV, VCR or DVD, Audio set-up codes, Volume / Mute features to their factory default settings.
11.
Additional Programming Information, Troubleshooting, Terms
Additional Programming Information
1. The power / mode buttons will illuminate in slow-rotation (i.e. S-A
Æ
TV
Æ
VIDEO
Æ
AUDIO
Æ
MOT…) while
the remote is in a programming mode. In the absence of a keypress entry, the power / mode buttons will stop
illuminating after 45-seconds and the remote will exit the programming mode.
2. When programming the remote control using the [CH +] or [CH -] buttons (Power function) in the Point and
Press® Programming method, you may find a code that turns a device off but not back on. If this happens…
a. The correct code has not been found as you may have a code that operates some but not all of the
functions of your device. Continue pressing [CH +] until your device turn on.
OR
b. You may have gone past the correct matching code. Try pressing [CH -] one press at a time until you
find a code that turns your device back on.
3. When using the Point and Press
®
Programming method, you can also program your remote using buttons other
than the [CH +] or [CH -] as described in Section 5 as follows:
a. [VOL +] – to “go forward” through the codes using the “VOL +” function on your devices.
b. [VOL -] – to “go back” through the codes using the “VOL -“ function on your devices.
Note: When you find the correct code, the volume of the device being programmed will increase or
decrease.
c. [
S
] - to “go forward” through the codes using the “CH +” function on your devices.
d. [
T
] - to “go back” through the codes using the “CH –“ function on your devices.
Note: When you find the correct code, the channel of the device being programmed will increase or
decrease.
e. [
XX
] - to “go forward” through the codes using the “Fast Forward” function on your devices.
f. [
WW
] - to “go back” through the codes using the “Rewind” function on your devices.
Note: When you find the correct code, the fast-forward or rewind function of the device being programmed
will be performed. To simplify programming using these buttons, insert a VHS tape or DVD in the device
being programmed.
4. You can also program your remote using the other available functions as follows:
a. Press [SEL / OK], then [MUTE] together until the power / mode buttons illuminate in slow-rotation (i.e. S-A
Æ
TV
Æ
VIDEO
Æ
AUDIO
Æ
MOT…).
