3. External Connection
COM-2C-PE, COM-4C-PE, COM-8C-PE
31
In the case of COM-4C-PE
When using a COM-4C-PE, an alternative to connecting an external device directly to the connector on
the board is to use a connection conversion cable or connection conversion unit.
Converting the Interface Connector to 9-pin D-SUB,
Male
Connectors
Use a PCE37/9PS connection conversion cable (purchased separately) to connect to external devices
after dividing into four 9-pin D-SUB male connector channels.
Use separately purchased 9-pin D-SUB or equivalent cables to connect from the four individual
connectors.
- Connector used
37-pin D-SUB, male connector
Thumb screw :
UNC #4-40 (inch screw)
- Cable
9-conductor shielded cable
Cable length : 250mm
Conductor size : AWG#28
- Connector used
9-pin D-SUB, male connector
Thumb screw : UNC#4-40(inch screw)
- Applicable connectors
17JE-13090-02(D8C) (mfd. by DDK, Female)
.
.
.
SG
DTR 1
TxD 1
RxD 1
DCD 1
9
8
7
6
RI 1
CTS 1
RTS 1
DSR 1
5
4
3
2
1
CH1
SG
DTR 4
TxD 4
RxD 4
DCD 4
9
8
7
6
RI 4
CTS 4
RTS 4
DSR 4
5
4
3
2
1
CH4
CH1
CH2
CH3
CH4
Figure 3.3. Specification of “PCE37/9PS”
Connection conversion cable (Option)
Connection Conversion Cable (37M
→
9M x 4, 250mm)
PCE37/9PS
Cable (Option)
RS-232C Straight Cable with D-SUB9P (1.8m)
RSS-9M/F
RS-232C Cross Cable with D-SUB9P (1.8m)
RSC-9F