2. Setup
COM-2C-PE, COM-4C-PE, COM-8C-PE
15
Setting the Board ID
If you install two or more boards on one personal computer, assign a different ID value to each of the
boards to distinguish them.
The board IDs can be set from 0 - Fh to identify up to sixteen boards.
If only one board is used, the original factory setting (Board ID = 0) should be used.
Setting Procedure
To set the board ID, use the rotary switch on the board. Turn the SW1 using, for example, a standard
screwdriver, to set the arrow to the board ID.
BOARD ID
(Board ID = 0)
Factory setting:
SW1
01
23
4
5
67
9A
B
C
D
EF
8
Figure 2.4. Board ID Settings (SW1)
