6
Fingernails and the luminescent tube should be in the same side.
6.1.2
6.1.2
6.1.2
6.1.2
Pulse
Pulse
Pulse
Pulse sound
sound
sound
sound setting
setting
setting
setting
After turning the device on,the pulse sound is open.Long press the button can close the pulse sound
and the pulse sound indication icon disappears.Long press button again, the pulse sound is turned on
and pulse sound indication icon appears.
6.1.3
6.1.3
6.1.3
6.1.3
Alarm
Alarm
Alarm
Alarm setting
setting
setting
setting
a.
Alarm includes the alarm of measure data's going beyond the limits (When the SpO
2
is below
90%, or the pulse rate is not between 50bpm and 120bpm,the alarm occurs), the alarm of low-power.
b. In the open state of alarm,when the measure data is beyond the the normal measure range, the
device would give alarm sound and the corresponding value glitter.Alarm could be suspended by
short pressing button,and the alarm icon disappears,but the value still glitter.Alarm function will be
renewed in 30 seconds.
If low-power alarm occurs,please charge the battery;and if the battery has been out of normal
life ,please replace it by a new one.
6.1.4
6.1.4
6.1.4
6.1.4
Display
Display
Display
Display mode
mode
mode
mode switch
switch
switch
switch
In the normal measure or alarm pause state,short press the button can switch the display mode of the
screen.
6.1.5
6.1.5
6.1.5
6.1.5
Charge
Charge
Charge
Charge
Put the rechargeable buttony battery properly according to the polarity direction in the charger.
Connect one end of the adapter to the power supply socket,and connect another end of the adapter to
charger by data line.
The power adapter of the device accords with the requirements of IEC 60601-1.
The charger accords with the requirements of IEC 60601-1.
In charging state, the red indication light of the charger will shine,the green indication light of
the charger shining means the charge has been accomplished.
6.2
6.2
6.2
6.2
Attention
Attention
Attention
Attention for
for
for
for operation
operation
operation
operation
A.
A.
A.
A.
Please check the device before using, and confirm that it can work normally.
B
B
B
B
.The finger should be in a proper position (see the attached illustration of figure 4 for reference), or
else it may result in inaccurate measure.
C.
C.
C.
C.
The ray between luminescent tube and photoelectric receiving tube must get across subject’s
arteriole.
D.
D.
D.
D.
The oximeter should not be used at a location or limb tied with arterial canal or blood pressure
cuff or receiving intravenous injection.
E.
E.
E.
E.
Ensure nothing, such as a plaster, can impede the light passage., or else it may result in inaccurate
All manuals and user guides at all-guides.com
