Contec HPC-HLS10 Series, Руководство по оборудованию

Страница: 9 / 39

1. Introduction
4 IPC-PT/MV10 / IPC-PT/LS10 / HPC-HMV10 / HPC-HLS10 Hardware Manual
(2)LCD backlight: Display brightness decreases over time with use.
The operating lifetime of the backlight is as follows (the time until the
brightness is lowered to 50% of the initial value):
- IPC-PT/MV10, IPC-PT/LS10, HPC-HMV10, and HPC-HLS10
: 50,000 hours
(3)Touch panel: The operating lifetime of the touch panel is at least 1 million touches
(as tested by mechanical touching under 300 g of force at a rate of
two presses per second).
(4)AC power supply: The life expectancy of the AC power supply is about six years for
continuous operation of the unit (installed vertically) at 40 degrees
centigrade. Note, however, that it is shortened depending on the
operating temperature (when used at high temperatures).
(5)24VDC power supply : The life expectancy of the 24VDC power supply is about six years for
continuous operation of the unit (installed vertically) at 40 degrees
centigrade. Note, however, that it is shortened depending on the
operating temperature (when used at high temperatures).
(6) Flash memory (NFDISK): The number of times of rewriting has restriction that is 300,000.
Since CF-CARD is used for Flash memory (NFDISK), When use is
carried out for the use that rewrites frequently, be careful of the
number of times of rewriting.
* CONTEC accepts your request for replacing each consumable in the PANECON-PC as a request
for repair (at an additional cost).
- If installed horizontally (with the LCD panel face up), the unit should be used at an ambient
operating temperature of not greater than 30 degrees centigrade.
- Be sure to turn off the power before plugging or unplugging any expansion board or connector.
- CONTEC reserves the right to refuse to service a product modified by the user.
- In the event of failure or abnormality (foul smells or excessive heat generation), unplug the power
cord immediately and contact the sales representative you purchased the product from or the
CONTEC Information Center.
- Use an AC cable that is compatible with both the rated supply voltage and the receptacle.
- This product contains a lithium battery as the primary cell and a cold cathode tube for the backlight.
When disposing of the product, therefore, treat it in accordance with the disposal regulations
stipulated by your local government.
CAUTION
To connect with peripherals, use a grounded, shielded cable.