Contec COM-2(PCI), Руководство пользователя

Страница: 28 / 80

Board Setup
COM-2(PCI), COM-4(PCI), COM-8(PCI)
21
For Windows 95 version 4.00.950B or 4.00.950C systems:
(1) Set the board ID.
(2) Be sure to check that the personal computer is off; then plug
the board into a PCI bus slot in the system.
(3) Turn the personal computer on to start up Windows 95.
(4) Because this is the first time Windows 95 detected the board
from the system, Windows 95 will display a message of [New
Hardware] on the screen and start run an [Device Driver
Wizard] program. After you find a massage of [PCI
Communication Device] from the program window, click
[Next>] to continue.
(6) In the next dialog box, select [Specify Location...]. Insert the
attached FD into a drive, enter the drive name and directory
name (COMDRV) in the [Location] field, then click [OK].
(7) In the next dialog box, there should be a message of "Updated
driver found for this device". After confirmed this message you
click [End]. This completes installation of the board. After
completed the board installation, you are supposed to confirm
the registered board information from Windows 95 registers.
The "Checking resources" part of this section explains you
how to do it.
(7) After restarting system, run Config.exe from\CONTEC folder
to which file was copied.
Register the COM port No. in Config.exe.
(8) After restarting system, you can use registered COM port as
standard COM port.
When dialog of [The file "*.*" on CONTEC COM-x(PCI) Series
Windows COM Driver could not be found] is indicated during the
installation, specify "A:\COMDRV" in [Copy files from].