Contec COM-2(PCI), Руководство пользователя

Страница: 23 / 80

Board Setup
COM-2(PCI), COM-4(PCI), COM-8(PCI)
16
(7) In the [Windows driver file search for the device] dialog box,
check that "CONTEC Co., Ltd.-COM-x(PCI)" and
"COM2K_PI.INF" in the [Location of driver] has been listed,
then click [Next>] to continue.
(8) In the next dialog box, you will find a message of “Windows
has finished installing the software that your new hardware
device requires.” Then you click [Finish] to complete the
installation of the board. After completed the board
installation, you are supposed to confirm the registered board
information from Windows 98 registers. The "Checking
resources" part of this section explains you how to do it.
(9) After restarting system, run Config.exe from\CONTEC folder
to which file was copied.
Register the COM port No. in Config.exe.
(10) After restarting system, you can use registered COM port as
standard COM port.
Method of installing two or more boards:
(1) Install the first board correctly.
(2) Be sure to complete installation of the first board before
attempting to install a second one.
(3) Exit Windows 98 and turn the personal computer off.
(4) Set the board ID of the second board that should be different
from the first one. Then plug the board into a PCI bus slot.
(5) Turn the personal computer on and start the Windows 98 again.
(6) The Windows 98 will then automatically install the second
board. When the installation has been completed, re-check
the assigned resources.
(7) After restarting system, run Config.exe from \CONTEC folder
to which file were copied. Enter the COM port No. in
Config.exe.
(8) After restarting system, the board enable the board to used as
standard COM port.