illuminated button will go out after 40 seconds.
3. When locking in your devices, the illuminated mode
button will blink 2 times and go off.
4. When using the Point and Press™ Programming
method, you may find a code that turns your device off
but not back on (after pressing [MUTE]). If this
happens…
a. the correct code has not been found. Continue
pressing [CH
p
] until your devices turn on and off.
OR
b. you may have gone past the correct matching code.
Try pressing [CH
v
] one step at a time until you find
a code that turns your devices back on.
5. If you have a Scientific Atlanta 8500 series converter,
press [CH
^
] or [CH
v
] to turn on the converter. Press
[CABLE] to turn these converters off.
6. Your remote control will automatically shut itself off if the
same key is pressed and held for 45 seconds. This
extends battery life in the event the remote becomes
lodged under or between large, heavy objects.
7. To reset your remote to its original settings…
a. Press [DEVICE], then [MUTE] together - hold both
buttons down until the lighted mode buttons start
blinking in sequence.
b. Press [CABLE]. The [CABLE] button illuminates.
c. Press [*Help], then [*HELP]. The [CABLE] button will
blink 3 times and go out.
8. When programming your TV, VCR, or AUXILIARY
devices, you may find several setup codes that can turn
on / off a specific device. However, not all of these
codes may operate all the functions on the device bring
programmed. Be sure to use the setup code that
operates all the functions on the device you are
programming.
9. If you have any questions concerning the operation of
your CABLE converter, contact your cable operator.
Rev. 11/2000
© 2001, CONTEC CORPORATION
