Contec AO-1608L-LPE, Руководство пользователя

Страница: 69 / 77

6. About Hardware
62
AO-1616L-LPE, AO-1608L-LPE
Hardware specification
AO-1616L-LPE
Table 6.1. Specification < AO-1616L-LPE >
Item Specification
Analog output
Isolated specification Unisolated
Number of output
channels
16ch
Output range Bipolar ± 10V
Absolute max. output
currency ± 3mA
Output impedance 1 Ω or less
Resolution 16bit
Non-Linearity error *1 ±
5LSB
Conversion speed 10 µ sec
Buffer memory 1k Word
Conversion start trigger Software / external trigger
Conversion stop trigger Number of sampling times / external trigger/software
External start signal LVTTL-level (Rising or falling edge can be selected by software)
Digital filter (1 µ sec can be selected by software)
External stop signal LVTTL-level (Rising or falling edge can be selected by software)
Digital filter (1
µ
sec can be selected by software)
External clock signal LVTTL-level (Rising or falling edge can be selected by software)
Digital I/O
Number of input channels Unisolated input 4ch (LVTTL-level positive logic)
Number of output channels Unisolated output 4ch (LVTTL-level positive logic)
Counter
Number of channels 1ch
Counting system Up count
Max. count FFFFFFFFh (Binary data,32bit)
Number of external inputs 2 LVTTL-level (Gate/Up)/ch
Gate (High level), Up (Rising edge)
Number of external outputs LVTTL-level Count match output (positive logic, pulse output)
Response frequency 10MHz (Max.)
Common section
I/O address 64 ports
Interruption level Errors and various factors, One interrupt request line as INTA
Connector 10250-52A2JL[3M]
Power consumption (Max.) 3.3VDC 310mA 12VDC 410mA
Operating condition
0 - 50
°
C, 10 - 90%RH (No condensation)
Bus specification PCI Express Base Specification Rev. 1.0a x1
Dimension (mm) 121.69 (L) x 67.90 (H)
Weight 70g
*1: The non-linearity error means an error of approximately 0.1% occurs over the maximum range at 0 ° C and
50 ° C ambient temperature.
Board Dimensions
[mm]
121.69(L)
67
.9
0(
H
)
The standard outside
dimension(L) is the distance
from the end of the board
to the outer surface of
the slot cover.