Constructor CRH1300-18M, Оригинальное руководство пользователя

Страница: 18 / 38

Page 18 of 38
or accident. Check tightness of screws
carefully before operation.
7. In cold weather or when the tool has not
been used for a long time, let the tool warm
up for a while by operating it under no load.
This will loosen up the lubrication. Without
proper warmup, hammering operation is
difficult.
8. Always be sure you have a firm footing.
Be sure no one is below when using the tool
in high locations.
9. Hold the tool firmly with both hands.
10. Keep hands away from moving parts.
11. Do not leave the tool running. Operate the
tool only when hand-held.
12. Do not point the tool at any one in the area
when operating. The bit could fly out and
injure someone seriously.
13. Do not touch the bit or parts close to the
bit immediately after operation; they may be
extremely hot and could burn your skin.
14. Do not operate the tool at no-load
unnecessarily.
15. Some material contains chemicals which
may be toxic. Take caution to prevent dust
inhalation and skin contact. Follow material
supplier safety data.
BEFORE USING THE TOOL FOR THE FIRST
TIME
▪
Examine the place where the device is to be
used for hidden electrical cables, gas and
water pipes using a pipe finding device.
▪
Before connecting to !he mains, ensure care
that the mains voltage corresponds to the
details on the rating plate.
▪
Ensure that the power switch is in the OFF
position. If the plug is connected to a mains
while the power switch is in the ON position, the
power tool will start operating
immediately, which could cause serious
accidents.
▪
When the work area is removed from the
power source, use an extension cord of sufficient
thickness and rated capacity. The extension cord
should be kept as short as practicable.
Fitting and changing tools
The device is equipped with a SDS-Max
attachment system.
▪
Clean tools and grease with a thin layer of
machine grease before fitting.
▪
Pull back fastening sleeve and hold.
▪
Push and rotate the dust-free tool into the
tool holder as far as it will go. The tool will lock
automatically.
▪
Check that it has locked by pulling the tool
Removing SDS-Max tool
Pull back fastening sleeve, hold and remove tool.
Accessories can be hot
after use. Don’t touch the
tip of accessory by hand!
Please always use
protective floves to remove
accessory.
SAVE THESE INSTRUCTIONS.
WARNING
MISUSE or failure to follow
the safety rules stated in
this instruction manual may
cause serious personal
injury.
ELECTRICAL SAFETY
Always check that the
power
supply corresponds to the
voltage on the rating plate.
DESCRIPTION
1. SDS Chuck
2. Fastening sleeve
3. Auxiliary handle
4. Oil cover
5. Lock on button
6. (Anti Vibration System)
7. On/off switch
8. Handle
OPERATION
Switching ON/OFF
▪
Switching on: Press the operating switch
(7).
▪
For continuous operation just press the lock-
on button (5) on the left side of the handle. the
lock-on button can be release by pressing the
switch trigger again.
Handle attachment
For reasons of safety, only use the hammer drill
with handle attachment.
You will be able to obtain a safe body position
when working by rotating the handle attachment.
Use
▪ After placing the tip of the tool on concrete
surface, switch the tool ON.
▪ By utilizing the weight of the machine and by
firmly holding the demolition hammer with
both hands, you can control the subsequent
recoil motion.