24
Drive belt replacement
▪ Remove the belt cover by unscrewing
the 3 installation bolts.
▪ Wear gloves, turn the driven pulley by
one hand slowly and pull the belt out by another
hand until the belt fallsl out of the pulley.
▪ To install the belt proceed in reverse
order.
Planing
▪ Choose the desired cutting depth before
operation.
▪ Hold the planer with one hand on the
switch and the other hand on the adjustment
knob.
▪ Place planer’s shoe on the surface to be
planed. Making certain that the cutting blades
are not touching the surface.
▪ Push down firmly on the adjustment knob
of the planer. So that the planer’s base is
completely flat on the work piece surface.
Depress the lock
-
off button and push the trigger
switch. Allow the motor to reach full speed
before starting to plane.
▪ Move the tool slowly over the work piece
and maintain downward pressure to keep the
planer flat. Be particularly careful to keep the
tool flat at the beginning and the end of the
work piece surface.
ATTENTION: Never change
the cutting depth while
operating , to not create
any irregularities on the
planed surface.
Edge chamfering
▪ Your planer has a precision machine
groove in the front base for planing along a
corner of the wood. It’s a good idea to try a
scrap piece of wood before doing final pieces.
Dust extraction
▪ When using the planer dust will be
generated.
▪ Always use the dust bag supplied with
your product.
▪ The dust extraction outlet can be
connected to an external vacuum cleaner to
extract while operating.
CLEANING AND MAINTENANCE
Attention! Before
performing any work on
the equipment, pull the
power plug.
Service
▪ Only qualified specialist personnel and
original replacement parts should be used for
repairs. This will ensure that your device
remains safe.
Cleaning
▪ Keep the ventilation slots of the machine
clean to prevent overheating of the engine.
▪ Regularly clean the machine housing with
a soft cloth, preferably after each use.
▪ Keep the ventilation slots free from dust
and dirt.
▪ If the dirt does not come off use a soft cloth
moistened with soapy water.
Never use solvents such
as petrol, alcohol,
ammonia water, etc. These
solvents may damage the
plastic parts.
Checking and replacing the carbon brushes
The carbon brushes must be checked on a
regular basis.
_
Remove the carbon brush holders and clean
the carbon brushes.
_
In case of wear, replace both carbon brushes
at the same time.
_
Mount the carbon brush holders.
_
After mounting new carbon brushes, let