2
SLPBWP
Wireless
Controller
The SLPBWP controller can control multiple heaters within its RF range. The RF range can be extended if necessary,
see product code SLEXT. The SLPBWP is rated IP65 making suitable for outdoor use. The controller has 3 operating
modes. The required mode must be set prior to the installation by using the switches located on the back of the
controller. These modes are:
Timer
Basic
Temperature Control
Please read this guide carefully and retain for future use and maintenance.
Installation and User Guide
1. Getting to know your SL wireless controller
In timer mode, switch 3 and/or 4 must be in the ‘ON’ position. This mode allows for 3
different settings which will alter the time period .
Switch 3 - Time period of 15 minutes.
Switch 4 - Time period of 30 minutes.
Switch 3 & 4—Time period of 60 minutes
2. Timer Mode
For timer mode, the switches are set as shown below.
Controller functionality in timer mode:
In timer mode, the controller acts as a run-back timer. When the controller is in stand-by mode and the button is pressed,
the light indicator will light up green and heating is activated. Once activated the indicator will change from green to
light blue showing it’s in run-back mode. Once the timer has run out, the light will go red and de-activate the heating.
If the button is pressed when the controller is in run-back mode, this will cancel the time and de-active the heating.
WARNINGS
Do NOT use the appliance if damaged.
Do NOT leave the appliance unattended where young children
are present.
Operating temperature range -10 to +40ºC.
Heating
Active
Stand-By
For basic mode, the switches are set as shown below.
Controller functionality in basic mode:
Press button to activate heating, press button again to set controller to stand-by.
When heating is active, the light indicator is green. After pressing the button, heating is set to stand-by; the indicator
will change from green to red for 4 seconds and then go off.
3. Basic Mode
4 seconds
