D F 2 S L H E A T F L O W : I N S T A L L A T I O N G U I D E
5
Step 17:
Tighten the two screws in the keyhole slots.
Ensuring not to over tighten.
(17)
Step 18:
It is possible to bend or move the LED indication light
when installing. Check this is straight and pointing away from
the wall.
(18)
(19)
Step 19:
Install the lid, this must be inserted at the
bottom and hinged upward.
(20)
Step 20:
Place the lid on the heater and ensure that you have
not clamped any leads. Using the screws in the screw pack, fix
the lid using the 3 fixing points.
(21)
Step 21:
Insert the screw covers if required.
(22)
Step 22:
Wire the end of your flex into the Fused connection
unit. This heater must be permanently connected to the
electricity supply via a double pole switch having 3mm gap on
each pole. There are no exceptions. A switched Fused
Connection unit to BS.1363 is recommended.
