Unpacking the unit
Carefully remove the unit from the carton and remove all packing material from the unit. Make
sure that you have all the following items:
• Main unit (x1)
• User manual
If any item is missing, consult your dealer immediately. We suggest that you retain the original
carton and packing materials in case it is necessary to return your unit for service. This is the
only way to protect the unit from damage in transit. When you dispose of the carton and
packing materials, please do so properly. We care about our environment. Remove any
descriptive labels or stickers from the front panel of the unit. Do not remove any labels or
stickers that may be affixed to the bottom of the main unit or the speakers.
Precautions for the unit
Security
• Before operation, check if the voltage of the unit is in line with the local voltage.
• Hold the plug to disconnect it from the mains outlet. Do not pull the power cord.
• When the plug of the unit is connected to the mains outlet, the unit will be still connected to
AC even of the power is turned off.
• Disconnect the plug as soon as liquid or objects enter the unit. The unit cannot be used until
being checked by experts.
• Do not open the cabinet. Laser rays employed by the unit may damage eyes. Any servicing
should be done by qualified service personnel.
Placement
• Put the unit where ventilation is good enough to prevent overheating.
• Never put the unit in direct sunlight or near heat sources.
• To protect the pickup, do not put the unit where there is a lot of dust. If there is dust on the
pickup, use a cleaning disc to clean it. Refer to the operation instructions of the cleaning disc
you bought.
Condensation
• The unit is suddenly moved from a cold place to a warm place.
• Use of the unit in a humid place.
• In these cases, the unit will not work. Unloading the disc and leaving the unit on for about one
hour will evaporate the water, allowing the unit to function normally again.
Cleaning
• Use a soft cloth with a little neutral detergent to wipe the cabinet, panel and controls. Never
use abrasive paper, polishing powder or any solvent such as alcohol or gasoline.
P.3