Conrad 75 15 57, Руководство по эксплуатации

Страница: 67 / 138

Problem Possible cause Solution
Motion detection Motion detection area not set See the following chapters:
is not working correctly. Sensitivity level not 12.2.2 "MD Setup - Area
correctly selected correctly. Setting" Submenu
12.2.1 "MD Setup -
Sensitivity" Submenu
12.1 "Motion Detection"
Submenu
Other Operational problems Unplug the plug-in power unit
from the mains socket-outlet.
Wait 10 seconds and reinsert
it. Switch the monitor on.
16. Remote Control Battery Replacement
If the range of the battery supplied begins to decrease, it is necessary to change the
batter (type: CR2025, 3V/DC).
To ensure proper battery replacement, proceed as follows:
• Take the remote control in hand and remove
the battery compartment out as shown in the
right of the figure.
• Remove the used battery.
• Place a new CR2025 (3 V/DC) type battery in
the correct polarity (the plus must face to the
back side of the remote control) in the battery
holder.
• Slide the battery compartment carefully on to
the remote control again.
66