32
Repairs other than those just described should only be performed
by an authorised electrician.
Technical data
Radio camera
Receiver
Operating voltage
9 V DC
12 V DC
(plug-in power unit)
(plug-in power unit)
Current consumption
200 mA
200 mA
Transmitting frequency
2.4-Ghz
2.4-Ghz
Modulation
FM
FM
Channels:
3
3
Light sensitivity:
5 Lux
Video output level
1 Vp-p / 75 Ohm
Audio output level,mono
1 Vp-p / 600 Ohm
Audio + video
3.5 mm jack->cinch
connecting jack
Picture sensor
1/3” CMOS colour
Horizontal resolution
330 TV lines
Microphone
Capacitor microphone,
mono
Picture
Colour:
Range
approx 100 m at free visibility
Operating temperature
0°C to +50°C
Mass
135 g
110 g
Dimensions without aerial
W x H x T in mm
100 x 38 x 40
112 x 82 x 18
Plug-in power units
Operating voltage
230 V~ / 50 Hz
230 V~ / 50 Hz
Output voltage
9 V DC / 200 mA
12 V DC / 200 mA
21
No part of the product may be modified or converted. Do not open the housing!
The safety instructions must be followed at all times!
Connection and operating elements
(fold-out page)
Radio camera
1
Rain protection cover
This covering can be pushed forwards or backwards.
2
Camera lens
1/3” colour CMOS sensor with rigid lens
3
Fastening/tripod thread
For fastening the camera on the supplied tripod (10).
4
Operating voltage jack
Connecting jack for the low-voltage plug (9) of the plug-in power unit with an out-
put voltage of 9-V DC (pay attention to correct voltage).
5
Microphone
A highly-sensitive capacitor microphone on the inside of the housing.
6
Transmitter aerial
The aerial transmits the high-frequency signal of the transmitter part.
7
Fastening/tripod thread
For fastening the camera on the supplied tripod (10).
8
Channel selection switch under a protective covering
Three different transmission channels can be set with the slide switch.
9
Plug-in power unit with low-voltage plug
The supply voltage is pending at this plug for the radio camera.
Pay attention to the output voltage of 9 V DC (!)
10 Tripod/wall fastening with ball and socket joint
The camera with the tripod thread can be connected here and aligned as desired.