These operating instructions are a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1,
D-92240 Hirschau (www.conrad.com).
All rights including translation reserved. Reproduction by any method, e.g. photocopy, micro
fi
lming,
or the capture in electronic data processing systems require the prior written approval by the editor.
Reprinting, also in part, is prohibited.
These operating instructions represent the technical status at the time of printing. Changes in
technology and equipment reserved.
© Copyright 2012 by Conrad Electronic SE.
Maintenance and Care
• The product does not require any maintenance, never take it apart. The LED lights are per-
manently installed; they cannot be replaced.
• Before carrying out any cleaning, the product is to be switched off and separated from the
mains voltage by pulling the plug-in power supply from the mains socket.
• The outside of the housing should only be cleaned with a clean, soft, dry cloth. Do not use
aggressive cleaning agents or chemical solutions that could damage the housing (discolour-
ing) or impair operation.
Do not press too hard on the surfaces, as scratches might appear.
Dust can easily be removed using a clean, soft brush and a vacuum cleaner.
Handling
Ꮨ
• The product is only to be used in closed, dry indoor locations. The product must
not get damp or wet! There is a risk of a life-threatening electric shock!
• Never use the product immediately after it has been taken from a cold room to a
warm one. The condensation that forms might damage your unit. The wall plug
transformer also poses a risk for a potentially fatal electric shock!
Allow the product to reach room temperature, before connecting it to the power
supply and putting it into use. This may take several hours.
• Avoid the following adverse conditions at the installation location and during trans-
portation:
- Excessive humidity or damp
- Extreme cold or heat, direct sunlight, proximity to heaters
- Dust or
fl
ammable gases, fumes or solvents
- Strong vibrations, impacts or blows,
- Strong magnetic
fi
elds such as those found in the vicinity of machinery or loud-
speakers
• Any maintenance or repair work may only be performed by an authorised repair
shop.
• When setting up the product, ensure that the cables are neither bent nor squeezed.
Install all cables in such a way that nobody may trip over them.
Disposal
Dispose of an unserviceable product in accordance with the relevant statutory regu-
lations.
Technical Data
a) LED strip
Operating voltage ......................12 V/DC
Light source ...............................12 LED per LED strip
Colour temperature ....................Warm white
Protection class .........................III
Dimensions ................................per LED strip 300 x 9 x 7 mm (L x B x H)
b) Wall plug transformer
Operating voltage ......................100 - 240 V AC, 50-60 Hz
Output ........................................12 V/DC, 1 A
Protection class .........................II
c) General
Total power consumption ...........approx. 8,1 W
