e) Making a cappuccino
You can make a cup of cappuccino by topping a cup of espresso with frothed milk.
Note: When making steam, the metal funnel must be assembled in position.
1. Follow the steps in “MAKE ESPRESSO COFFEE” to prepare an espresso, and make sure
that the steam knob is at the “O” position.
2. Press the coffee/steam button “
” to the lower position and wait until the steam indicator
(green) turns on.
3. Fill a jug with about 100 grams of milk for each cappuccino. For best results, use whole milk
at refrigerator temperature (i.e. not hot).
4. For best results, keep the steam knob in the open position for approx. 15 seconds and then
keep the knob at the “O” position for the next step.
5. Insert the steam wand about 2 cm into the jug with milk in it, and then slowly turn the steam
knob anticlockwise. Steam will come out from the steam wand and frothed milk is produced
by moving the milk jug up and down.
Note: Never touch the steam outlet during use.
Note: Never turn the steam knob rapidly, as steam will accumulate rapidly in a short time
which may increase the risk of explosion.
6.
When you have finished frothing the milk, turn the steam knob to the “O” position.
7. After frothing, follow the instructions below to prevent the steam outlet from becoming
blocked:
Place an empty jug under the steam wand and then turn the steam knob and press the
pump control button “
” to the lower position. The pump will start to pump water. After
water has flowed for 30 seconds, press the pump control button “
” to the higher
position, and then clean the steam outlet with a wet sponge.
8. Press and release the ON/OFF button “
” to turn off power to the appliance.
9. Pour the frothed milk into the prepared espresso. Sweeten if desired and sprinkle the froth
with a small amount of cocoa powder.
Note: If the steam outlet is blocked, turn the steam knob to the “O” position and allow the
coffee maker to cool down for approximately half an hour. Poke the steam outlet several
times with a needle of about 1 mm in diameter. Then press the coffee/steam button “
”
and turn the steam knob to check if the appliance can produce steam normally when the
steam indicator (green) turns on. If the appliance still cannot produce steam, contact the
customer service department.
f) Frothing milk/producing steam to heat liquids
The steam wand can be used to froth milk and make hot beverages such as drinking chocolate,
water or tea.
1.
Remove the tank and fill it with the desired amount of water (the water level should not
exceed the “MAX” mark in the tank). Then insert the tank into the appliance.
2. Connect the appliance to the power supply.
3. Press the ON/OFF button “
” to turn on the unit. The power indicator (red) will turn on.
4. Press the pump control button “
” to the lower position, making sure that the coffee/
steam button “
” is at the higher position. The pump will start to pump water. When
water starts to flow, turn off the pump immediately.
5. Press the coffee/steam button “
” to the lower position and wait for a moment. The
appliance will start to heat. Wait until the (green) lamp turns on, which means that heating
is finished.
6. Dip the steam wand into the liquid to be heated. To froth milk, dip the steam wand about
2 cm into the milk. Slowly turn the steam knob anti-clockwise to start making steam.
7. When you have obtained the desired result, turn the steam knob to the “O” position.
8. After frothing, follow the instructions below to prevent the steam outlet from becoming
blocked:
Place an empty jug under the steam wand and then turn on the steam knob and press
the pump control button “
” to the lower position. The pump will start to pump water.
After water has flowed for 30 seconds, press the pump control button “
” to the higher
position, and then clean the steam outlet with a wet sponge.
9. Press and release the ON/OFF button “
” to turn off the power source.
Note: If the steam outlet is blocked, turn the steam knob to the “O” position and allow the
coffee maker to cool down for approximately half an hour. Poke the steam outlet several
times with a needle about 1 mm in diameter, and then press the coffee/steam button “
”
and turn on the steam knob to check if the appliance can produce steam normally when the
steam indicator (green) turns on. If the appliance still cannot produce steam, contact the
customer service department.
g) Automatic power-off function
The appliance will turn off automatically 25 minutes after the ON/OFF button is pressed.
Care and cleaning
a) Cleaning
Do not use aggressive cleaning agents, rubbing alcohol or other chemical solutions.
They damage the housing and can cause the product to malfunction.
Do not immerse the product in water.
1. Disconnect the product from the mains before cleaning.
2. Let the coffee maker cool down completely.
3. Regularly clean the housing, water tank, drip tray and removable shelf with a moisture-proof
sponge, and then leave them to dry.
Note: Do not clean with alcohol or solvent cleaner. Never immerse the housing in water
for cleaning.
4. Detach the metal funnel by turning it clockwise. Dispose of coffee residue and then clean
with a mild detergent before rinsing with clear water. Do not wash the metal funnel in
a dishwasher.
5. Clean all the attachments in water and dry thoroughly.
Note: To ensure optimal function, clean the appliance after each use.
b) Descaling
To ensure optimal function and coffee flavour, it is recommended to descale the appliance
every 1-2 months.
1. Fill the tank with water and descaler to the MAX level (use a ratio of 4:1 for water and
descaler). For details, refer to the instructions on the descaler packaging. For best results,
use household descaler. You can also use citric acid (available from a chemist or drug
store), using one hundred parts water to three parts citric acid.
2. Place the metal funnel (without coffee powder) and carafe (jug) in place and brew water in
accordance with the steps in the “PREHEATING” section.
3. Press the ON/OFF button “
” to turn on the unit. The power indicator (red) will turn on.
Press the pump control button “
” to the lower position, making sure that the coffee/
steam button “
” is at the higher position. When water begins to flow, turn off the pump
by pressing the pump control button “
”. The coffee maker will then start to heat up.
4. The coffee indicator (green) will turn on when preheating is complete. Press down the pump
control button “
” to the lower position and make two cups of coffee (about 2 Oz). Then
turn off the pump and wait for 5 seconds.
5. Press the coffee/steam button “
” to the lower position and wait until the green indicator
turns on. Make steam for 2 minutes and then turn the steam knob to the “O” position to stop
making steam. Press the ON/OFF button “
” to turn off the unit, and then leave the
descaler in the unit for at least 15 minutes.
6. Restart the unit and repeat steps 4-6 at least 3 times.
7. Press and release the coffee/steam button “
” to the higher position. When the green
indicator turns on, press down the pump control button “
” to the lower position until no
descaler is left.
8.
Brew coffee (without coffee powder) with tap water filled to the MAX level and repeat steps
4-6 three times (it is not necessary to wait 15 minutes as in step 6), and then brew until no
water is left in the tank.
9. Repeat step 9 at least three times to make sure the piping is clean.
Troubleshooting
Problem
Cause
Solution
Water leaks from
the bottom of the
coffee maker.
There is a lot of water in the
drip tray.
Clean the drip tray.
The coffee maker is malfunc-
tioning.
Contact an authorized service centre
for repair.
Water leaks from
the side of the
filter.
There is some coffee powder
on the edge of the filter.
Remove the coffee powder.
The coffee has an
acidic (vinegar)
taste.
The appliance was not
cleaned correctly during
descaling.
Follow the steps in “Before first use”
and repeat several times to clean the
coffee maker.
The coffee powder was
stored in a hot or damp place
for a long time.
Use fresh coffee powder, or store
unused coffee powder in a cool, dry
place. After opening a packet of coffee
powder, reseal it tightly and store it in
a refrigerator to maintain its freshness.
The coffee maker
does not work.
The coffee maker is not
plugged into a wall outlet.
Plug the power cord into a wall outlet.
If the appliance still does not work,
contact an authorized service centre
for repair.
The steam does
not froth milk.
The steam indicator is not
illuminated.
Wait until the steam indicator is illumi-
nated before frothing milk.
The container is too big, or
the shape does not fit.
Use a high and narrow cup.
Skimmed milk was used.
Use whole milk or semi-skimmed milk
