|
11
5A Speed Control
10
| Manual
this uniVersAl pulse wiDth controller
allows
the step less control of the speed of DC motors without barely
any loss. By using pulse width control (0 to 100%) the loss is
extremely small even at low resolutions of the motor. An integrated
short-circuit protection prevents that the device is destroyed.
technicAl DAtA
Power supply: 9 to 16 V dc
max. output: 5 a
Parts width control: 0 -100%
switching frequency: approx. 1 khz
connectible loads: resistive and inductive
dimensions: 100 x 70 x 20 mm this
5 A speeD control
for dc motors
Art.-No. 19 02 19
GB
Read the instruction manual carefully before operating the device!
No liabilities will be taken for damages or claims resulting out of not reading
and/or not following the user guide and/or any form of modification on or in
the product. Under these circumstances, no warranty services will be given.
Liability will not be taken for consequential damages.
note!
This device has left the factory in the technically safe condition. To keep the
device technically safe and to install and use the device safely the user must
read the instruction manual and security notes carefully and follow them.
1.
DesiGnAteD use
The device has been designed for the speed control of 12 V DC motors with a
maximum power of 5 A. Any other use is not allowed.
2. operAtinG conDitions
– The device may only be connected to the operating voltage defined in the
specifications.
– The device can only control a motor with a maximum of 5 A as defined in the
specifications. Controlling a larger motor will lead to malfunction, destroy the
device and can cause harm to connected devices and people.
– When connecting the device, make sure that cable with sufficient cross section
is used.
– When connecting the device make sure that connected devices are sufficiently
protected and fused.
– The controller can be installed in any position.
– The device should not be used in the near vicinity of high-frequency fields or
magnetic fields as this can lead to malfunction.
– The surrounding temperature should not be below 0°C or exceed 40°C during
use.
– The device may only be used in dry and clean rooms.
– Protect the controller from water, dampness, dirt and heat.
– The controller may not be used in the direct vicinity of easily inflammable
liquids.
– This device is not a toy and should not be used by children under the age of
14.
– This device should not be handled or installed by persons with reduced
physical, sensory or mental capabilities or lack of experience (including
children) other than if supervised by a trained, responsible person.