Conrad Electronic FAZ3000-FB-2, Руководство по эксплуатации

Страница: 11 / 24

11
as described below (‘Re-entering or changing the security code’) if you wish
to enter a new security code.
6. At the time of the initial operation, the LED (
3
) on the front side blinks
for approximately 20 seconds; this indicates that it is ready to accept the
security code input.

The LED goes out if you do not enter the security code within these
20 seconds.
Pressing any button activates the entry mode again for 20
seconds.
7. Enter the 9-digit security code using the three buttons of the remote control
(only at the time of the initial operation):
‘
ext. ’ button (
1
) : Numerical value: 1
‘ int. ’ button (
2
) : Numerical value: 2
‘ unscharf ’ (disarm) button (
4
) : Numerical value: 4
Example: 142142142
8. The LED goes out after entering the security code; the remote control is
ready for operation. The remote control can be now registered to the alarm
base station, see section 8 on page 12.
Re-entering or changing the security code (for instance, in case of a
wrong input or to change the security code):
1. Keep the ‘ ext. ’ button (
1
) pressed.
2. After about 5-6 seconds, the LED lights up for approximately five seconds
and then goes out. Release the button only after that.
3. The LED starts to blink.
4. Proceed from step 7 above to enter the security code.

Please note:
If the remote control has been already registered to the alarm base
station using a particular security code, you must delete this
security code from the alarm base station
before changing it.
The remote control can be registered again to the alarm bas station
after entering a new security code.